Applies to: Danalock V3 BTZBx, BTZx, BT-HK
Exclude
To exclude a Danalock from a smart home setup, you’ll need to follow your hub/gateway guidelines.
The process differs from manufacturer to manufacturer.
But in general, follow these instructions.
Z-wave
To exclude a lock from a z-wave setup you will have to start an exclusion process on the hub.
It’s best to do this on the hub on which the lock is included.
In some cases like with the Aeotec Smart Home Hub / Samsung Smartthings V3, you can set the hub in exclusion mode, and press the button behind the LED on the Danalock 1 time, to reset the inclusion.
Zigbee
To make the Zigbee lock leave the smart home setup, you can either delete the lock from the hub with the lock nearby or you can simply click the button behind the LED on the Danalock 9 times.
HomeKit
To remove the Danalock from HomeKit you click the button behind the LED on the Danalock 10 times. This not only resets the HomeKit registration on the lock but also the lock setting including calibration, so please remember to set your settings on the lock again and run a new calibration. To remove the lock entry in your Home app, simply remove it there.