Danalock V3
Manual Firmware Upgrade of Danalock V3 devices
Android guide
Download and install the Danalock Toolbox App from Google Play Store.
Open the app when the installation has completed.
While the app is open, your phone will continuously search for a lock in firmware upgrade mode.
Starting the Danalock device in Firmware Upgrade Mode:
Danalock V3:
- Remove one Battery Cell
- Press and hold the button in the small pin hole on top of the lock with a paper clip or similar object.
- Turn on the Danalock by reinserting the battery while holding down the button.
The Danalock will light up purple to indicate that it has been turned on in firmware upgrade mode. (The Apple HomeKit version will light up red)
Danapad V3:
- Remove one battery
- Press and hold the unlock button
- Turn on the Danapad by reinserting the battery while holding down the button.
The Danapad will show constant red light.
Danabridge V3:
- Turn off the power
- Press and hold the button in the small pin hole on top of the lock with a paper clip or similar object.
- Turn on the Danabridge while holding down the button.
The Danabridge will show constant purple light.
In the Danalock Toolbox App, the grey terminal area will switch from scanning to showing a description of the latest firmware version available.
Press “Upload New Firmware” in the bottom of the screen to manually upload the Danalock device firmware file you received from Support.
The firmware will now be uploaded and installed on the Danalock.
The Danalock will light up blue while connected to your phone.
You can follow the progress in the percentage bar in the terminal window.
When the firmware has been installed the, Danalock will turn off for around 30 seconds while applying the firmware installation.
When the Danalock finishes it will light up white for about 3 seconds. Please don't touch the Danalock until the setup has completed.
After completing the firmware upgrade, some setting might be reset.
Please check all settings and check calibration.
