Title | Download |
---|---|
Danalock-v3_scandi-ASSA2000_manual | Download |
Add tape to the cylinder on the outside of the door. This will secure the cylinder and prevent it from falling out while you are mounting the Danalock V3. Remove the inside part of the cylinder, and you are ready to go.
Find the supplied tailpiece kit.
Insert the new cylinder and re-insert the lock-screw in the mortise-plate to fix the cylinder. (b) Do not over-tighten the screw. Check that the cylinder is working by locking and unlocking with your hand.
Find the supplied back plate.
Affix the back plate with the breakable screws (supplied).
The tailpiece cannot extend more than 35 mm from the back plate.
If it does, break the tailpiece using two sets of pliers.
Locate the supplied tailpiece adapter.
Insert tailpiece adapter into the back of the Danalock.
Press until it clicks into place.
Fit the Danalock over the back plate. Ensure that the tailpiece hits the adapter.
Align the marks on the back plate and baseplate.
Turn the Danalock clockwise to fasten it to the back plate.
Remove the plastic strip to activate the batteries.
Note: Leave the door open during app setup for smoother calibration. Locate and download the Danalock app.
Create a user profile by selecting the blue ring. Use this profile to sign into the app going forward.
Once you have a user profile, use the green ring. Select "Menu" at the top right corner, then “Add lock”. A guide will lead you through installation and configuration.
To dismount the Danalock, insert a pen tip into the hole at the top inner edge of the lock. Press while turning the lock counter-clockwise until it releases. Dismounting will not reset the lock or disconnect it from your account, but it may need to be re-calibrated when reinstalled.